![]() Wake on Lan did not support profiles but this is solved in Kodi v14/Helix (Github PR).Wake on Lan could fail to wake servers specified by name (not ip-address) but this is solved in Kodi v14/Helix (Github PR).It will still wake the server and start playback, but visual feedback is poor. Wake on Lan can fail to bring up the progress-dialogue depending on where playback was initiated from.Wake on Lan can come 'out of sync' if you force-sleep the server (if server stays on shorter time than specified in parameter 'timeout' before it suspends).Wake on Lan does not wake UPnP-servers, including other Kodi- installations (Pending PR).Wake on Lan does not wake PVR-servers (Forum request).If using a different pingport it is normally not nessesary to add additional wait time. When using pingport = 0 (normal icmp ping) it is recommended to use waitservices = (ca) 5 to allow services on server to startup after server responds to ping. Port 21 (ftp), 22 (ssl), 23 (telnet) are also likely to work OK if your server has that service installed pingport = 3306 / pingmode = 1 - port 3306 is default MySQL port and useful if your server is the MySQL host.pingport = 445 / pingmode = 0 - port 445 is used by samba (windows file sharing) and can be used for 'ping-probing' (but only pingmode = 0).Time to perform extended wait for machine to wake upĪdditional time to wait after ping response, to allow server daemons to startup Time to wait for machine to wake up (advise is to set this to servers actual anticipated startup time) a good choice is to use same value as server's idle-timeout before entering sleep-mode Specifies how long time (default 600) of inactivity must pass before a new 'wake-on-lan' check is performed. ![]() Only applicable if pingport!=0, if 1 will not only connect to pingport but also wait until data is actually read back ![]() else a 'connect' attempt will be done to the specified port Ipaddress (or network name) of machine you want to wake upĭefault 0 which will perform ordinary icmp ping. Time to wait for network to be consistently connected before progressing Time Kodi will wait for network to (re)connect when booting or after resuming from suspend-mode While not required for basic operation, some additional settings can be made to the wakeonlan.xml file that is stored in the userdata folder. The autoscan will if necessary create a file called 'wakeonlan.xml' and will add entries for these servers including macaddress which should be picked up in the scan. When feature gets enabled or shares gets added an autoscan will be done for any servers specified, either in shares or in MySQL settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |